seagate Barracuda 5400.1 ST320015A Installation Guide free download

File name Seagate Barracuda 5400.1 ST320015A Installation Guide.PDF

Jumper settings for this drive are shown below Drive is master or single drive Drive is slave Barracuda 5400.1 Installation Guide Use cable select ST320015A Drive is master with non- ATA Interface Disc Drives ATA-compatible slave Master/slave jumpers (see table for key to jumper settings) Publication Number: 100280502, Rev. B, November 2003 The easiest way to install your drive 2. Mount the drive and attach cables a. Slide the drive into a 3.5-inch drive bay. You can mount the drive in any DiscWizardTM, available exclusively from Seagate, provides you with cus- orientation, but we recommend mounting with the circuit board down. tomized installation instructions for your hard drive. You can download Dis- Note. To mount the drive in a 5.25-inch drive bay, you must purchase cWizard for free from the Seagate web site at www.seagate.com/support mounting brackets, available from your computer dealer. or run the program directly from your web browser. In either case, you should run DiscWizard before you install your drive. b. Secure the drive using four 6-32 UNC mounting screws in either the side-mounting or bottom-mounting holes. Insert the screws no more If you cannot run DiscWizard, follow the instructions on this installation than 0.20 inches (5.08 mm) into the bottom-mounting holes and no sheet to install and configure your drive. more than 0.14 inches (3.55 mm) into the side-mounting holes. What you need